Rotary spray washing machine with air blow drying designed for bearings mounted on hanging type fixtures. The system provides high-pressure cleaning, filtration and effective air blow drying for reliable bearing cleaning and moisture removal.
The Rotary Bearing Cleaning Machine is designed for rotary spray washing and air blow drying of bearings mounted on hanging type fixtures. Bearings are rotated during washing and drying to provide uniform cleaning and effective removal of grease, dirt and other contaminants.
Aqueous-based environmentally friendly cleaning
Automatic cleaning cycle
Recycling and rinsing with rust inhibitor
Hot air blowing for moisture-free finish
Front-loading turntable with auto slip clutch
Automatic sludge removal system
Automatic solution level control
Loading
Open the door and mount the bearings on hanging
type fixtures. Close the door before starting
the cleaning cycle.
Wash Cycle
High-pressure spray of heated alkaline solution
is applied on the rotating fixture for thorough
bearing cleaning. Duration: 5–15 minutes.
Drain & Filtration
The pump stops and the cleaning solution drains
back to the tank through the filtration system.
Drip Cycle
The fixture continues rotating to allow excess
cleaning solution to drip back into the tank.
Duration: 30–60 seconds.
Air Blow Drying
Compressed air is blown onto the rotating bearings
from multiple directions to remove water and
moisture. Duration: 1–3 minutes.
Unloading Position
Rotation stops and the fixture moves to the
unloading position for convenient bearing removal.
End of Cycle
The door is opened and the cleaned, dried bearings
are unloaded. The machine is then ready for the
next cycle.
